n8casCT Posted March 12, 2011 Author Posted March 12, 2011 Okay, I actually sit down and get all my tools out and I'm all set to go to clean on of my symetre spinning reels and all I have to help is this...http://fish.shimano.com/publish/content/global_fish/en/us/index/customer_service0/reel_maintenance_instructions.download.-mainParsys-000100-downloadFile.html/Maintenance%20Tips-%20Spinning%20Reels%20(1%20page).pdf Is there a better DIY for spinning reels out there??? Quote
n8casCT Posted March 12, 2011 Author Posted March 12, 2011 Currently working on my 2 yr old Shimano Citica and besides a hair-brain moment (with removing the sideplate) I'm doing okay. But now I'm stuck at removing the retaining clip from the worm shaft I've tried using thin needle-nose pliers but I think I bent both the washer AND the retainer clip and have made no progress - If this was one of my better reels, I would be real ticked off - thanks to whomever said try it on an older reel first. Any suggestions would be appreciated. I've already ruined this reel (it will be my backup reel this year on the water - not mounted on any set up) Quote
Super User skunked_again Posted March 12, 2011 Super User Posted March 12, 2011 youve not ruined anything. i use a scribing tool to remove those. you need to dolly the clip out from the inside. Quote
Super User bilgerat Posted March 12, 2011 Super User Posted March 12, 2011 If you are serious about this, you will need to invest in some basic tools. If you have a decent hobby store in your area, you can find precision pliers, screwdrivers, etc. similar to what's on this site... http://www.micromark.com/?gclid=CJ7U3a30yacCFcfe4AodZSvLEg For screwdrivers I would suggest these...http://www.amazon.com/Wiha-26199-Slotted-Phillips-Screwdriver/dp/B000NZ5QG0/ref=sr_1_1?ie=UTF8&qid=1299963475&sr=8-1 They are the some of the finest made and they will last a lifetime. You should also have a small pick set in addition to good screwdrivers and a variety of pliers. A 1/4" drive socket set (metric) with shallow and deep sockets is helpful also. You could have walked that clip out with a tiny flat bladed screwdriver or a pick. ALWAYS keep a finger over clips as they will shoot across the room never to be seen again. You're on your way, just keep your head and learn to walk away for a few minutes when things get **itty. One more thing I do is note the orientation of every single piece. Often there are subtle differences between, for example, the two sides of a gear or washer. Schematics usually don't show the detail of smaller parts. Some guys take pictures, I sketch them on paper. Details are everything when it comes to working on reels. Quote
n8casCT Posted March 13, 2011 Author Posted March 13, 2011 I tried getting my thinnest flathead underneath but only bent one side and I bent the thin washer underneath too. Your right about "walking away" from time to time. I put it back together and it works, so that's a plus. Maybe tomorrow I will try to get at the worm shaft. The needle nose pliers I have are pretty small, but I could use a scribing tool like you had mentioned. thx Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.