sealer Posted December 15, 2010 Posted December 15, 2010 when tying a polamar knot with a small hook eye - whats the easiest way to get the doubled line through the eye ? thanks, dennis Quote
Super User Grey Wolf Posted December 15, 2010 Super User Posted December 15, 2010 how small of a hook and what size line ????? Quote
sealer Posted December 15, 2010 Author Posted December 15, 2010 8 # flouro with a #1 gamma dropshot hook thanks, dennis Quote
Super User BrianinMD Posted December 15, 2010 Super User Posted December 15, 2010 Easiest way is to pass the line thru not doubled over, pull a long tag then take the tag and and go back thru the hookeye the opposite way as the first time. Just be sure not to pull it the whole way thru again. This way you don't have to force the doubled over line into the small hole. Quote
Super User J Francho Posted December 15, 2010 Super User Posted December 15, 2010 Don't double it up first. String the hook up. Pinch the hook and line in one hand, and bring the tag end back through. You should have no trouble with this method, and your knots will be better since you aren't pinching the line. I use it on 8# line and #6 hooks without problems. Quote
Super User Catt Posted December 15, 2010 Super User Posted December 15, 2010 Easiest way is to pass the line thru not doubled over, pull a long tag then take the tag and and go back thru the hookeye the opposite way as the first time. Just be sure not to pull it the whole way thru again. This way you don't have to force the doubled over line into the small hole. Exactly Quote
B-Dozer Posted December 15, 2010 Posted December 15, 2010 Winter is a good time to practice. Soon you will be able to tie quicker than it takes to write this Quote
dulouz Posted December 15, 2010 Posted December 15, 2010 I have a question about tightening the knot. Is it best to pull the tag, the line, or both? I wet the knot, but it still curls when I tighten it down. So I have been pulling the tag to preserve the main line. However this seems to waste a lot of line, especially if I am tying on a large crank. What is the best way to pull it tight? Quote
Super User J Francho Posted December 15, 2010 Super User Posted December 15, 2010 Pull both, at first. Once the main line loop is snug, pull only the tag. The kink should be on the tag that cut off. If its on the mainline, before the hook, start over. Quote
endless Posted December 16, 2010 Posted December 16, 2010 Pull both, at first. Once the main line loop is snug, pull only the tag. The kink should be on the tag that cut off. If its on the mainline, before the hook, start over. Is that what makes the knot weak and pop? Quote
Super User J Francho Posted December 16, 2010 Super User Posted December 16, 2010 It weakens the line above the hook. Twists in the line and too much heat usually make a weak knot. Quote
Super User Catt Posted December 16, 2010 Super User Posted December 16, 2010 If the line has crossover it will cut into itself and break almost every time. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.