Jump to content

Recommended Posts

Posted

Hey Guys,

I recently bought a used boat. I have a tiller style boat and my boat motor does not have any electronics. Am I okay hooking up the boat electronics (bilge, lights) and a rear trolling motor to the same battery? Anything I need to be concerned about with how I hook it up? I'm very new to this.

Thanks, Mike

  • Super User
Posted

You should be alright - my old canoe I had the sonar, cameras and USB ports (camera and Tablet power) connected to the same battery as my MinnKota 30....never had an issue.

 

I do run 2 batteries now - one for the Edge 45, a second/smaller one for everything else.

  • Like 1
  • Super User
Posted

If you're running the fish finder at the same time as the motor there is a possibility that you'll have interference.  It depends on the motor and the specific unit and there's no way to predict it.  If its a problem then grab a small house battery later.

  • Like 2
  • Super User
Posted

^ If you do have some EMI/RFI interference on the sonar - it can usually be cleared up by putting a filter on the power supply to the sonar.

 

A Ferrite Ring Core is usually enough for low power (<24v) applications.

image.png.42ebaf8b0f6575b4981f66891f46ba89.png

https://www.amazon.com/uxcell-Ferrite-Cores-Suppression-Filter/dp/B07YJWYKFH/ref=sr_1_9?keywords=ferrite%2Brings&qid=1691161862&sr=8-9&th=1

  • Like 1
  • Thanks 1
Posted

You mught find you need a bigger battery, depending on how much power you draw.  I used to have a group 27 deep cycle battery rhat ran my fish finder, radio, and nav lights at night.  Also my bubbler in my minnow bucket, and a small not often used trolling motor with no charging off my motor....and that would last all day with no issue.  A deep cycle battery would be a must, and a good charger to recharge after use use....

  • Like 1
  • Super User
Posted

There's always a chance the TM can cause interference on your sonar display.  Doesn't hurt the sonar but can make the display do strange things.  Usually (if it does interfere with it) it will make black lines or dots across the screen when you run the TM.  

Getting a large enough battery would be the next concern if the motor is electric start only and keep it charged.  Not a lot of fun after running the TM for a while to go to start the motor and the battery is too weak.

Most small motors and older motors only have about a 15 amp charging system so it's not going to keep the battery charged if you use the TM much, don't care how long you run the gas motor, you will still need to charge your battery every time you come back home from using it.

 

 

  • Like 2
  • Super User
Posted

Is the OB a pull start or electric start?

Whenever you use 1 battery 12VDC marine it needs to to charged at the end of the outing.

You should also have a 50 amp circuit breaker so you don’t fry your TM or  electronics ( sonar unit).

Tom

Posted
On 8/4/2023 at 9:52 PM, WRB said:

Is the OB a pull start or electric start?

Whenever you use 1 battery 12VDC marine it needs to to charged at the end of the outing.

You should also have a 50 amp circuit breaker so you don’t fry your TM or  electronics ( sonar unit).

Tom

Pull start. 

  • Super User
Posted
25 minutes ago, Ersteman said:

Pull start. 

Good.  Then you won't need a "dual use" battery.  A regular deep cycle will be fine.  And even if you drain it all of the way, you won't be stranded.  

 

What kind of trolling motor do you have?  Does it have stepped speed settings (like 5 forward and 3 reverse) or is it infinitely variable?  If it has stepped speed settings, then it should be fine with the sonar.  If not, then it might cause issues.  But not every sonar and trolling motor have problems working off the same battery.  Typically, if it does, the easiest solution is to hook up your sonar to a second battery.  You can buy a cheap 7-12Ah 12v AGM battery for just the sonar.  Unless you're using a particularly large and fancy sonar unit, they typically just pull around 1 amp, so a 7-12Ah battery will last you 7-12 hours.  You might wear it out faster by draining it down all of the way so often (you're not supposed to drain a lead acid style batter below 50% capacity), but they're cheap enough that it won't matter.  And the smaller, lighter ones are much easier to carry.  

 

Also, check out the lithium batteries they out now.  Lighter, more power, and last longer.  They're more expensive, but it could be worth it for you.  

  • Like 1
Posted

All good answers.  If you're going to use your trolling motor for bass fishing it's far better to attach it to the bow.  I have a 14' boat with an electric start 25 and a 30 lb thrust trolling motor mounted to the bow with an L bracket.  No charging circuit on the engine but the battery lasts for a long time with a group 27 deep cycle battery.  Also a small fish finder on the same battery.

You have to turn the control head around for the bow mount, easy to do.

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.


  • Outboard Engine

    fishing forum

    fishing tackle

    fishing

    fishing

    fishing

    bass fish

    fish for bass



×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.