Replacing guides

[Weslewis]

Hello everyone, 

On my last trip i some how managed to bust 2 of my guides completely off my dobyns sierra. I contacted them and they sent me replacement guides for free which was awesome. I figured i could do it myself but looking for any tricks or tips. It is the 3rd and 4th guide down from the tip . I personally dont know of anyone or any shops around me that could fix it being in western Indiana. Any info would be greatly appreciated.  Thank you

[Chris Catignani]

Here's a video on the process. I personally dont heat the epoxy...I just cut the thread off on the top of the guide foot.

 

[spoonplugger1]

There is not now, nor has there ever been a reason to heat the wrap as noted above. Since hopefully this is a one shot deal you can just cut a V in a box to set the rod in and hand wrap the guides on, there is no need to put the thread on tight, just snug, multiple wraps over and over are your strength and stability. Remember to wash your hands well before handling the thread so there is not oils, or residue to fisheye your finish.

[Weslewis]

Awesome thank you!

[MickD]

Check this video out.  https://www.youtube.com/watch?v=slcWbnK5OPQ&list=PL70J_niOcbAVOe28mjFxAqx9xJ4CXl-Q0&index=7

You don't need all the Mudhole tools, a box as has been suggested + running the thread through a closed book (it's not critical, but you need some tension)  .  This will tell you how to start and finish the wrap, the biggest challenges for newbies. 

[spoonplugger1]

Remember to use finish on your wraps, not an epoxy adhesive like you get in the stores, they are completely different compounds, I would rather use varnish or clear nail polish then epoxy adhesive. Varnish is what all the old rods you see used and they are still used being today by many. A small can of Varathane Triple Thick shouldn't be hard to find if you can't get thread wrap epoxy.

[Delaware Valley Tackle]

I also recommend turning the rod by hand for the first one or two. Not only to save $ in case you decide this isn’t for you, but more importantly so you see and understand how epoxy finish flows and acts while drying. 

[A-Jay]

Every couple of years, almost always during hard water, I'll pick a stick or two to refresh.  

Usually just taking the stock guides off and then spinning them back on with new material.

If there's a need, I replace one or all with new.

No problem admitting I'm a total novice, but it's not really that difficult.

Taking my time and having the right tools & materials is as often the case, is helpful.

A-Jay