Seats

[VaAngler]

I was sitting here pondering. I put the rear seat pedastol on my boat i Cut a 4 inch access hole on the front of my bench seat and put the plastic screw cap thing on it made it look good. It allowed me to put 5/16ths bolts an some big ol' washers under it and really make it stout. My fishing buddy is no little fella. In doing all of this i had to channel the foam under the pedastal. tI was simalar to great stuff foam. I was wondering if i should spray something back over the spot, to mayb seal this or if it should be ok left as is. Figured you guys would have some great insight and experence with some thing like this. I like the access hole its big enough for my cell phone, camera, and boat and trailer registration.

[simplejoe]

My question to you is, How often do you fish in the rain?

If your like me and are out there in rain or shine, then I would seal it.

[VaAngler]

rain doesnt slow me down. Im not really sure what to seal it with a 2 part epoxy mayb,

[done]

I say, better safe than sorry. You will never seal it then go back and say "Darn! There is so much damage. I wish I did not seal that."

[VaAngler]

Good point. any siggestions on what would be good to seal it with? Mayb some sort of spray. any kind of suggestions on this please