Making my own baits

[chuck-norris-707]

So I have been researching and trying to find a good injector for plastisol and I have been trying to find all the supplies for for making my own worms 

[Jig Man]

Google bait making sites under ground.  You will find one that has every thing you need to know.

 

[chuck-norris-707]

thank you so much I am looking it up now... 

I looked it up, and I didnt find anything super helpful but thank you. I might use it for later referance.

[PourMyOwn]

Spend your money on the injector, don't go cheap. I have the Basstackle, and if I wanted out of pouring I could get my money back in less than a week. The high end stuff barely depreciates. 

 

Also get a nice respirator, and make sure you have ventilation.

 

The rest is up for debate, some guys use a microwave, others a presto pot... Some guys like Dead on Plastic, others prefer other brands. 

 

I use both ways to heat plastic and primarily pour remelts from guys who pour for profit. I don't sell stuff, I keep my fishing buddies stocked and I donate bags of baits to local high school teams. 

[Munkin]

1 hour ago, PourMyOwn said:

Spend your money on the injector, don't go cheap.  

Great advice! Get one with a locking nozzle as the first one I bought didn't. After blowing the nozzle of a few times I just bought a good one (think its as Basstackle?).

 

Allen

[chuck-norris-707]

thank you so much I have seen the injectors on amazon and read the reveiws on there injectors and they all said you need a injector with a locking mechanism so thank you 

[Jig Man]

16 hours ago, IneedAnewScreenName-974534 said:

thank you so much I am looking it up now... 

I looked it up, and I didnt find anything super helpful but thank you. I might use it for later referance.

You should read don’ts for newbies for sure.

[chuck-norris-707]

4 minutes ago, Jig Man said:

You should read don’ts for newbies for sure.

ok i will