WHAT AM I DOING WRONG HERE?

[jimmyjoe]

6 minutes ago, pauldconyers said:

Why are you encouraging me to over spool the reel?

   I would guess that what he meant was ensure that the line coming off the supply spool is coming off over the top of the spool, and not from under the bottom of the supply spool, which would  twist your line.       jj

[JustJames]

Added****

BTW do not apply Line Conditioner if you line not reel in properly, line conditioner will make your like kinked (only temporary, will straight out after you catch a few fish)
This post will be removed Within an hour. Lol

[CrankFate]

9 hours ago, jimmyjoe said:

   I just went and pulled both my Curado reels to make sure.

   If you reduce the drag pressure on a Curado (and I believe, but am not absolutely sure, any modern baitcaster) the spool can have an erratic function, or even no function at all while the levelwind is unaffected..

   Try this: reduce your drag to almost nothing. Put your thumb on the spool and crank the handle. You'll see the levelwind going back and forth even though the spool is being held motionless.

   You should be able to increase the drag to a point that it seems to have bite, but can still slip with a slight increase in drag resistance.

   This will do two things; 1) it will put the line take-up on the spool temporarily out of sync (like for a second) with the levelwind, resulting in either a slightly lower line level as the line comes across at a higher angle, or a buildup of line as the levelwind passes over the same point on the spool temporarily, before re-aligning itself.   2) With some lines, a friction point can build up at a certain spot on the spool.  Every time the levelwind passes over that point, the drag will "stutter" or momentarily reduce effectiveness. It will slip a small bit, in other words. This can result in uneven line lay.

   The solution is to tighten the drag down to AT LEAST the level you're going to use on the water. With thick lines, or when I used braid (I don't anymore) I tightened the drag down VERY tight, then loosened it up to the level I wanted to use on the water.

   So the advice everyone such as @Logan S, @CrankFate, @rangerjockey,  and @Russ E about line tension should be correct. And the point about getting to the complete supply of line on the spool like @JLewis134 said is important, too.

You can't tell if there's not a buildup all the way at the inside of the spool supply.

 

   Try these things, and ..... Good luck!    jj

  

^ This

[jimmyjoe]

1 hour ago, Bass_Fishing_Socal said:

okay for you spooling baitcaster 101 lol. I happen to need new line on SLX so I made some illustration for ya ?. First of all never reel in the line loose whatsoever when spooling or fishing. Make sure spool tension set as normal like when you fishing, drag set enough to be able to reel the line with some pressure.

1. Simple station if you don’t wanna use pickup stick and you toes.

 

2 you case of backing, I’m not sure what in there but this reel I picked #12 Hybid line with double uni knot. Make sure the line come out from top of filler spool and not twisted.

 

3. always have thumb and index finger on your line to apply tension as need. If you ever fish conventional reel, you learn how to move you finger along the length of spool. This case also I move my finger with line guide to help it go in evenly (not thick on one side as you see a lot when ppl apply tension on one spot). You can do this while walking back to the line that been pulled out as well.

 

 

4. the end result, perfect every time. Make sure to take easy on first few cast.

 

Added****

BTW do not apply Line Conditioner if you line not reel in properly, line conditioner will make your like kinked (only temporary, will straight out after you catch a few fish)
This post will be removed Within an hour. Lol

 

   You have a knack for making things crystal-clear. Congrats!   jj

[OnthePotomac]

I can only add that I have 3 Curado K's and 10 other Shimano reels and  have had this problem

[MickD]

It doesn't matter with a baitcaster being filled from a rotating spool whether it comes off the top or bottom.  just not the edge of a stationary spool.

[dodgeguy]

I bury my spool in the hamper under my clothes and reel the line on through the rod guides with a tight drag. It goes on nice and straight and even that way.

[VolFan]

I have a modified Dodgeguy technique - especially for re-spooling braid. Take it to an open area of your choice. Walk the line off. Tie end to an old towel or tshirt. Reel line in. Great tension this way, you get exercise and can stay socially distanced.

[dodgeguy]

also make sure your line is tied to the spool and not slipping all day long..

[WRB]

The OP's photo looks like he missed the opening in the level wind, the spooled line is to the right side. The spool tension knob could very loose or almost falling off!

Tom

[APK62]

7 hours ago, dodgeguy said:

I bury my spool in the hamper under my clothes and reel the line on through the rod guides with a tight drag. It goes on nice and straight and even that way.

Great idea, no need to use scent on your lures !  

[dodgeguy]

1 hour ago, APK62 said:

Great idea, no need to use scent on your lures !  

LOL

[Quarry Man]

I like to spool my line very similar to the way @Bass_Fishing_Socal does it. I made my own out of scrap wood and metal I had lying around. First reel I purchased, the guy at the  store spooled it for me. He messed it up, so I said "if you want it done the right way, do it yourself" 

 

That being said, here's how I spool casting reels (modified over 4 years):

1. Remove old line from reel
2. Place reel on a rod (I prefer a broken rod with only the first guide from the reel seat)
3. Thread the line through the first guide from reel seat (at least) AND reel guide as well.

***If spooling braid, add 10-12 lb mono backing OR electrical tape - must be at least enough to cover the spool***

1. Use modified uni knot with only 3 wraps to attach backing to spool
2. Pull tightly and rotate spool in both directions
3. Ensure the knot AND reel guide are centered
4. Cut line as close to spool as possible to prevent interference later on
5. Spool enough line to cover the exposed spool, like I mentioned with electrical tape
6. Attach main line via modified double uni knot with 3 wraps per side
7. Double check to make sure line is threaded through the line guide of the rod and the reel, and that your drag is very tight, along with spool tension knob
8. Place the spool somewhere that will allow the spool to spin vertically with line spinning FROM THE TOP
9. *** I tend to use my spooling station, but a friend and a pencil works, basically any method of keeping the spool stable and upright will work***
10. Boil a small pan of water, enough to saturate the entire spool
11. Wait for the boiling water to cool to around 100ish plus degrees (will vary)
12. Place the spool into the water for a few minutes. you may need to add weight to keep it submerged
13. *** Above step not necessary with braid***
14. Acquire a moist cloth to place between your hand and the line while spooling
15. Begin spooling the reel by reeling at a constant rate until the line reaches the lip of the spool. Check for smooth lay while reeling. maintain pressure as well, this makes sure the line lays smooth and without kinks,
16. Cut line off, spray KVD Line N Lure or similar spray.
17. Wait 30 mins
18. Spray again and cast in yard or other dry area
19. spray the deeper line that becomes exposed after a cast.

 

There ya go, my how to on spooling a casting reel the best way. This is my at-home diy version. I don't tend to spool reels on the water, but if I had to, I would remove the heating and line conditioning, as I don't tend to carry boiling water and line in lure (tends to spill) while i'm on the boat. This is not how I spool spinning reels. will be happy to explain or show if need be.

 

Conclusion

I know this is somewhat unrelated to OP's question, but spooling your reels correctly is important, OP likely did not spool his reel correctly. I started doing it myself four years ago and have been learning since. this is my current method and has been for about a year now.

 

like almost anything, especially in fishing and (s*x), the more you do something the better you get .