what octane gas do you run in your outboard?

[NJfishinGuy]

hey just wondering what octane do you guys run in your outboard? i know my manual says no lower than 87 but would it be better with 89 or 91 or 93 octane? not sure what most people run theirs on.

Ryan

[fishingfourfun]

Regular 87 octane

[Live.2.Fish]

I run 87.  I have heard that if you OB manual says to run 87 and you run premium (91), you can actaully gum up your motor.  

[GABassin]

I run 87 because where I live the gas is so expensive but I have ran 93 before and it felt like I had a lot better performance. I marked speed with both octanes' on the same gps and I got 4 mph faster with the same load and conditions using the 93. I have never heard that about the 93 gumming the motor either. I am not sure how it would when it is a higher quality fuel.

[NJfishinGuy]

i think it could because it doesnt burn all the fuel off maybe... i think i might run 89 and see how she runs. not go up to 91 but not use the lowly 87 lol

[Guest JoshKeller]

most outboards (excluding high performance) recommend using basic 87 octane.

[bassmaster8100]

i run 93 just seems to run better with higher octane gas for me

[RWHusker.]

I have ran 91 to 93 (premium) because I was told to by the service person I bought the boat from.  The manual says 87.  I was also told to use a $15 carbon burning additive and absolutely no ethenal.  What are other thoughts.

Rod

GO BIG RED

[Pa Angler]

Regular 87 octane

Same here that's what Mercury recommends.

[Way2slow]

You are not doing a low compression 87 ocatane motor any good running a higher octane.  Actually, just the opposite.  Higher octane fuels burn slower and colder, and will cause more carbon buildup.  

Some of your early 80's and almosty all 70's and older motors are a different situation.  They came along long before this junk we have for gas now and most of them have too much compression to safely run todays 87 octane so I would be wise to run premium in those.  

If it says 87 octane, run 87 octane unless you let your gas sit for a month or two.  Gas looses octane rather quickly so if you let the boat sit for more than a month, it might pay you to add as much 93 octane as you have old gas in the tank.  If for some rare occasion one of my boat sits for more than two months with gas in it, I won't run that gas, it comes out.

[Pa Angler]

You are not doing a low compression 87 ocatane motor any good running a higher octane. Actually, just the opposite. Higher octane fuels burn slower and colder, and will cause more carbon buildup.

Some of your early 80's and almosty all 70's and older motors are a different situation. They came along long before this junk we have for gas now and most of them have too much compression to safely run todays 87 octane so I would be wise to run premium in those.

If it says 87 octane, run 87 octane unless you let your gas sit for a month or two. Gas looses octane rather quickly so if you let the boat sit for more than a month, it might pay you to add as much 93 octane as you have old gas in the tank. If for some rare occasion one of my boat sits for more than two months with gas in it, I won't run that gas, it comes out.

Your wasting gas, I guess you never heard of stabilizer I use it every winter have never had any problems.

[bassmaster8100]

Ive ran a little of both but 93 is whats worked best for me, my boat never sits long tho Im out every week of the year in it, if it sits for 2 weeks its a miracle, does matter to me if its 20 degrees or 120 degrees Im on the water. Water rarely freeze down here in south mississippi so I fish year around so dont have to worry about stabalizer.

[Black Bass]

I run 89 in my '76 Evinrude 85 HP. As suggested above, being an older motor I could probably run 93 octane and gain some performance. However, because I'm cheap, 89 is my compromise.

[R520dvx]

87 octane regular

[john087]

87 octane but you can always add additives to your fuel to rid the engine of carbon build up once a year, that saves you a lot of money

[Way2slow]

Stabalizer????  The Seafoam I run also performs as a stabalizer.  You can put your faith in stabalizer, you can run six month or 16 month old gas, it's your motor.  As I stated, it's rare for one of mine to sit long with gas in them and that usually get used in the mower, so I wouldn't consider it wasted.  I think the few gallons of gas pulled out of my tank is a lot cheaper than rebuilding a powerhead.

Keeping fresh gas is even much more critical now with the High Tech motors of today than ever before.  The carb motors of a recent past time ran low compression and had a lot of cushion built in for those that think it's ok to park a boat in the fall and take it back out the next summer with the same gas in it.  These newer computer controlled, DFI and four stroke motors are pushing the compression to the limit.  You will can find out real quick just how expensive that few gallons of gas you didn't want to "waste" can be with those.  

[Redlinerobert]

91 octane in my Mercury Racing 300.

[Pa Angler]

Stabalizer???? The Seafoam I run also performs as a stabalizer. You can put your faith in stabalizer, you can run six month or 16 month old gas, it's your motor. As I stated, it's rare for one of mine to sit long with gas in them and that usually get used in the mower, so I wouldn't consider it wasted. I think the few gallons of gas pulled out of my tank is a lot cheaper than rebuilding a powerhead.

Keeping fresh gas is even much more critical now with the High Tech motors of today than ever before. The carb motors of a recent past time ran low compression and had a lot of cushion built in for those that think it's ok to park a boat in the fall and take it back out the next summer with the same gas in it. These newer computer controlled, DFI and four stroke motors are pushing the compression to the limit. You will can find out real quick just how expensive that few gallons of gas you didn't want to "waste" can be with those.

6 months, 16 months I never said that but over winter it works and is recommended by the Tracker dealer for all of the Mercs including the Optimax there's a reason it's called S T A B I L I Z E R it does just that keeps the fuel from going bad for months I guess it's your choice not to believe that but it has proven itself without a doubt that it works. Didn't mean to ruffle your feathers but in PA water gets stiff and my outboard won't run on ice so that stuff has to be used I do try to run the tank down as far as I can on my last outing but I never run it empty.

[striperone]

Way2slow hit the nail on the head in regards to octane. I don't have to add a thing to that post.

Fuel Stabilizer.

I have owned a bass boats for over 25 years. I had never added stabilizer because I would always run my boat all season long including through the winter months and not once experienced a problem. BUT, one year I didn't take the boat out during the winter, come spring the motor wouldn't run (carburated merc bridgeport) $400.00 in repairs to the gummed up fuel system put me back on the water. Not to mention that my boat was at the repair shop for over a month in the spring. So needless to say I would recommend using the stabilizer.

[Jeff_NHBA]

87 Octane for my 02 150 XR6.  No need for the high test stuff.

[NJfishinGuy]

Stabalizer????  The Seafoam I run also performs as a stabalizer.  You can put your faith in stabalizer, you can run six month or 16 month old gas, it's your motor.  As I stated, it's rare for one of mine to sit long with gas in them and that usually get used in the mower, so I wouldn't consider it wasted.  I think the few gallons of gas pulled out of my tank is a lot cheaper than rebuilding a powerhead.

Keeping fresh gas is even much more critical now with the High Tech motors of today than ever before.  The carb motors of a recent past time ran low compression and had a lot of cushion built in for those that think it's ok to park a boat in the fall and take it back out the next summer with the same gas in it.  These newer computer controlled, DFI and four stroke motors are pushing the compression to the limit.  You will can find out real quick just how expensive that few gallons of gas you didn't want to "waste" can be with those.  

hows the seafoam work out for ya. ive used it in my cars and it can sometimes work wonders for smoothing out a rough motor. i was thinking about running it thru my outboard.  do u just run it through the gas or have u done the striaght into thr carb method

[Jeff_NHBA]

Stabalizer???? The Seafoam I run also performs as a stabalizer. You can put your faith in stabalizer, you can run six month or 16 month old gas, it's your motor. As I stated, it's rare for one of mine to sit long with gas in them and that usually get used in the mower, so I wouldn't consider it wasted. I think the few gallons of gas pulled out of my tank is a lot cheaper than rebuilding a powerhead.

Keeping fresh gas is even much more critical now with the High Tech motors of today than ever before. The carb motors of a recent past time ran low compression and had a lot of cushion built in for those that think it's ok to park a boat in the fall and take it back out the next summer with the same gas in it. These newer computer controlled, DFI and four stroke motors are pushing the compression to the limit. You will can find out real quick just how expensive that few gallons of gas you didn't want to "waste" can be with those.

hows the seafoam work out for ya. ive used it in my cars and it can sometimes work wonders for smoothing out a rough motor. i was thinking about running it thru my outboard. do u just run it through the gas or have u done the striaght into thr carb method

Add it to the tank, just like your car.

[NJfishinGuy]

in my car i pop off the brake booster cable and feed 1/3 can striaght into the motor and shut it down for 10 mins then start it and let it smoke out.

[Way2slow]

I run it in the gas at 1 ounce per gallon.  Every 50 hours or so I run some straight into the throttle bodies on my Ficht and straight into the carbs on the carburated motors.  After running the motor with a pretty good dose having gone through them, I give one super size shot in each so it stalls the motor and let it sit overnight.

As for feathers ruffled, not mine.  I only post what I do or what I would do in a similar situation and make recommendations.  I could absolutely, 100%, care less what anybody else does with their equipment, that's why there are repair shops.   I just base my methods on about 45 years of personal experience racing, building and modifing boats and motors and just messing with boats, and they work just fine for me.

[NJfishinGuy]

can you give me an estimate on how much you use straight into the carbs?