How do i get started?

[WoolleyBass]

Hey everybody,

I have been checking out all your guys baits and they look amazing and i want to try to start making my own. So my question is how what do i need to start making some balsa and PVC baits?

Thanks for any info

   Roby

[Fishwhittler]

The main tools I use:

Bandsaw (a scroll saw also works)

Drill

Adjustable square for marking the centerline on the bait

Utility knife for carving

Needle-nose pliers & vise-grips

Dremel tool

The main materials I use are:

PVC trim board

19 gauge stainless steel wire

Lexan sheet

5-Minute epoxy

That should help you get started. Here's a link to the Swimbait Compilation Thread. That was a thread all about building swimbaits, but a lot of the info applies to any kind of hard bait.

I'd also recommend you look around at the older posts in this forum. There's tons of info there regarding just about every aspect of lure-making.

I hope this helps.

Ben

[WoolleyBass]

Sweet! I have all of that except the materials. Thanks a ton Ben

    Roby