Super User tcbass Posted June 8, 2015 Super User Posted June 8, 2015 I know some do it in the fall before they store their boat, some do it in the spring, and others do both (even though they change out lube that that was put in to store the boat but never turned on). I read that doing it in the fall prevents storing your boat with use lube and contaminants which could be bad for it. When do you change your outboard/inboard's lower unit gear lube? Quote
Super User Jig Man Posted June 8, 2015 Super User Posted June 8, 2015 I like to do it spring and fall. Quote
Chief 2 Posted June 8, 2015 Posted June 8, 2015 I would do it prior to storing it. That way if there has been any water intrusion you will know and it will be ready to go in the spring. 1 Quote
Super User Way2slow Posted June 8, 2015 Super User Posted June 8, 2015 If you live in a climate that you have freezing temps during the winter, it's best to do it in the fall before storing the boat. If it happened to develop a leak and got water in it, you risk two problems. One, the water freezing and cracking the gear case, and second, that long period between fall and spring gives the water time to rust the gears. As for twice a year, unless it's for commercial use or you are fishing the FLW or BASS schedule, you most likely would never put enough time on it to warrant two changes a year. 2 Quote
Super User WIGuide Posted June 8, 2015 Super User Posted June 8, 2015 If you live in a climate that you have freezing temps during the winter, it's best to do it in the fall before storing the boat. If it happened to develop a leak and got water in it, you risk two problems. One, the water freezing and cracking the gear case, and second, that long period between fall and spring gives the water time to rust the gears. As for twice a year, unless it's for commercial use or you are fishing the FLW or BASS schedule, you most likely would never put enough time on it to warrant two changes a year. ^^ This Quote
Super User tcbass Posted June 8, 2015 Author Super User Posted June 8, 2015 Someone who changes theirs in the spring say they open it up in the fall to see if there is any water in the lower unit, and if not, they then close it up and change it in the spring. If there isn't any water coming out they're good. If water comes out they know they may have a problem and bring it into the shop. Quote
Super User S Hovanec Posted June 8, 2015 Super User Posted June 8, 2015 In a perfect world, I'd change it in the fall. That never seems to happen though and by the,time I get around to fall boat maintenance, it's too cold to drain the oil. So, spring has been it for a,while. Quote
Super User rippin-lips Posted June 8, 2015 Super User Posted June 8, 2015 It's part of my late fall routine before storing it. Quote
desmobob Posted June 9, 2015 Posted June 9, 2015 I change mine in the fall when I put the boat up for the winter. Tight lines, Bob Quote
Vayned Posted June 9, 2015 Posted June 9, 2015 Will have to change mine before I get it out on the water. Quote
Super User Ratherbfishing Posted June 10, 2015 Super User Posted June 10, 2015 Change the who? The what? Quote
Super User WIGuide Posted June 11, 2015 Super User Posted June 11, 2015 In a perfect world, I'd change it in the fall. That never seems to happen though and by the,time I get around to fall boat maintenance, it's too cold to drain the oil. So, spring has been it for a,while. Too cold to drain oil? Quote
Nice_Bass Posted June 11, 2015 Posted June 11, 2015 I usually change it in the dead of winter when I am bored. Stored in its own garage and big door is never opened but I keep a thermometer in there. usually never goes below 40 except when it got -30 2 years back and dropped the garage temp to about 30 I think, not sure as I was too busy with cookie pans and hair dryers unfreezing pipes in the house. Quote
Super User S Hovanec Posted June 11, 2015 Super User Posted June 11, 2015 Too cold to drain oil? Gear lube doesn't flow too good when its 30° or colder. Takes hours to drain completely. Quote
Super User WIGuide Posted June 11, 2015 Super User Posted June 11, 2015 Gear lube doesn't flow too good when its 30° or colder. Takes hours to drain completely. Interesting, never thought of that. I haven't had that issue when it's cold though. Quote
Al Wolbach Posted June 11, 2015 Posted June 11, 2015 I always put the ears on and run the motor for a couple of minutes. It heats up fast and I use synthetic lube which helps with draining also Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.