Rod Repair

[NBR]

I have an old but favored graphite rod that the tip is broken off. Just putting a new tip guide on is not an issue. I've done it many times. On this break the tip is shattered an 1/8 inch or less and I need to cut just a smal piece off. Any suggestions on how to cut a little piece off with out shattering the fibers.

Thanks,

[S Hovanec]

Wrap a piece of masking tape around the blank where you want the cut to be. Use a cut-off wheel on a Dremel or a flat file to file away the section that's bad.

[KDW96]

Wrap a piece of masking tape around the blank where you want the cut to be. Use a cut-off wheel on a Dremel or a flat file to file away the section that's bad.

A coarse sharpen stone works also as does a battery operated hook sharpner like the berkley line stripper with stone on the end,

[SirSnookalot]

Wrap a piece of masking tape around the blank where you want the cut to be. Use a cut-off wheel on a Dremel or a flat file to file away the section that's bad.

yep

[.RM.]

Wrap a piece of masking tape around the blank where you want the cut to be. Use a cut-off wheel on a Dremel or a flat file to file away the section that's bad.

X2 ..