Jump to content

Search the Community

Showing results for tags 'trim'.

  • Search By Tags

    Type tags separated by commas.

  • Search By Author

Content Type


Forums

  • Fishing Forums
    • General Bass Fishing Forum
    • Introductions
    • Smallmouth Bass Fishing
    • Fishing Reports
    • Bass Clubs
  • Bass Boats & Fishing Equipment
    • Fishing Tackle
    • Bass Boats, Canoes, Kayaks and more
    • Tacklemaking
    • Fishing Rods, Reels, Line, and Knots
    • Rod Building and Custom Rods
    • Marine Electronics
  • Bass Fishing Tournaments
    • Tournament Talk
    • Fishing Résumés
  • Fishing Locations
    • Southeast Bass Fishing
    • Northeast Bass Fishing
    • Central Bass Fishing
    • Western Bass Fishing
    • International Bass Fishing
  • More Topics
    • Other Fish Species
    • Fishing Flea Market
    • Everything Else
  • Hunting
    • Hunting Forum
    • Gun Forum

Find results in...

Find results that contain...


Date Created

  • Start

    End

Last Updated

  • Start

    End

Filter by number of...

Joined

  • Start

    End

Group

Location

My PB

Favorite Lake or River

Other Interests

Found 2 results

  1. bcarter261
    Hi Guys, Been lurking a really long time here on Bassresource and this is my first post! Anyhow I was hoping some of you guys may be able to help me figure out what's going on with my power tilt/trim. I believe I need to bleed the cylinders (rams) because recently it stopped staying all the way up when raised. I noticed today the hoses were leaking pretty bad on the bottom of the pump so I tightened those up and checked the oil which was pretty low. I went ahead and filled it, then cycled the system up and down several times to bleed it. This system has the reservoir inside the boat with lines to the rams. It has two rams one on each side of the outboard. It's a 35 hp I believe an '86. Please let me know if there are any details I can fill in to help find a solution.
  2. KilgoreBass
    I'm at a loss trying to find a replacement for my tilt trim motor. The model number of the engine is 115593E. It's a 1975 Evinrude 115. Recently bought the boat and this was the only thing wrong. I'm guessing he backed into something. All bent. Is it feasible to find a replacement? Do I replace the whole assembly? Sorry about no pics. I tried. The Motor has an axle that protrudes into the hydraulic section about 3.5 inches. I mention this because I haven't seen any like this when I try to look them up. The bottom half of the assembly has the numbers 317016. Thanks, -Nate
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.