Mapper

Well, the two of you were correct, the bearings that I bought did not work. Although I measured with a micrometer, and ordered bearings that were extremely close to my measurements, they did not fit properly. I ordered from China and they took a few weeks to get here, so I was only out a total of less than $10.00. Lesson learned, listen to other fishermen. Thanks.

Thanks for your input and suggestions. Boca Bearing is supposed to make bearings that fit the 3.2x10x4mm bushings that I want to replace, but those are costly, and I went with a less expensive alternative. Using a micrometer the spool shaft and ID of bushings measure 3.2 mm. If this conversion works, I will post results.

I have a vintage (1958-1959) Abu Garcia Ambassadeur 5000 and will be replacing the bushings with bearings soon, when they arrive. My question is, the bushings have a little tag that fits into a slot. I suppose this tag keeps the bushing stationary, from spinning. The bearing will not have that tag. Will the bearing remain stationary or will the outside of the bearing spin? Or, should I even be concerned? Thanks

Pretty sure I found the date of the Johnny Morris JMX10SHD. It was most likely built in 2005. Thanks for all of your input. It is in like new condition, not a scratch or mark on it, smooth as silk.

Yeah that picture looks a bit like the one I bought. It came with braided line on it, which is something I have not used yet. Thanks for the info. I will take it to Bass Pro next week and have them match a rod to it. Also got an Abu Garcia Ambassador 5000 that looks like it has never seen action. According to serial number it was made in 2002. Need rod for that one too.

Nice to know those reels have some longevity, thanks

Thought it might have been made a few years ago. I will take it to Bass Pro next time I go there. Thanks

Does anyone know how to determine age of a Johnny Morris bait casting reel, Model number JMX10SHD? I bought it at an auction and is in like new condition.