Thanks for your advice. Here is the situation, my motor seems to have lost some horse on both hole shot and top end. Checked compression on it and all is good. Runs great out of the water on the dyno. Runs good with just one person and empty livewells. Add another person and fill up the livewells, and I have to have the second person go to the bow to get it to break over. It doesn't ever rev like it used to on the hole shot with the hammer down. It revs to about 3000 and stays there until it finally breaks over then it will only rev to about 4800-4900. It has always in the past run at 5300 rpms for top end speed. Starts everytime without much problem except once, it may have just been a fluke but cranked till the batteries were dead, pulled it out charged batteries for a little while, backed it back in fired right up. New carb kits, new plugs and wires still need all the help anyone can give. Thanks
