Brinkley

Thank you Bolar for your response!!

I have had my Heritage out 4 times since I took delivery June 14th. Today when I went to remove seat post from the rear deck it would not turn. Took a pair of channel locks to post and it turn and turn and turn,....took small nail puller and pry it up to remove. It appears that the base is no longer straight where the threaded shaft goes in (front just drops right in and screws into place to mount sect on). Has anyone else had this issue? Is this something that maybe covered under warranty? Also, has anyone mounted their TM foot control in one of the recessed boxes or just bolted/screwed to floor or have just left it loose? If recessed box mount, was it mounted off center to right/left?

Thank you for the info. I will look into the keel shield. Local dealer/installer for Hamby stared “ it won’t seal properly on the extruded keel on that Heritage boat and may not stay on because water would get behind it.”

Probably not intentionally but wanted to protect aluminum keel just in case.

I just purchased a Tracker Heritage 40th anniversary edition aluminum boat. I would like to install a keel protector. Anyone have any info on doing this with the Heritage boat. It has an extruded keel. Was told by local installer for Hamby products they would not go on and seal probably. Also, recess for trolling motor pedal. Thanks