CaliBassRipper

Thanks for the tips. Went back at it this weekend and a great 30+ fish day. Didnt have anything break but kept on a look out for abrasions to the line and not one break so it was prob just the rocks. But the fluoro i was using as a leader just sucked there was a kink it every few ft that was week so i believe i found my solutions.

That makes alot of sense about the guides il check that. The line should still be good its not very old and kept inside my house. But real good advice.

Im not sure if this was the problem it was a 1/4 oz jerk but that may of been a contributimg factor to by the braid With the braid it was right by the knot not real sure if it was at the knot. And the fluoro the same thing i was at a full cast when i got hit and broke off. But it did look like a clean break.it wasnt frayed or anything. I did forget to mention i was fishing around alot of rocks. After reading all this im starting to think i may have just nicked one when ripping it around. It atleast sounds more plausible then a bad knot Or bad line since it happened on 2 different lines?

Ya definitely not the case here. im in central california haha. Have you guys used a loop knot. For jerks

Thats good to know. Ya i have no idea what was going on. both those knots never fail me until now. But do you use the uni on fluoro and braid? And are you using this light of line or heavier.

I sell the stuff i bought i dont use and use that money to get new toys il sell later lol endless perfect cycle and the women dont get mad.

So i was out fishing the other day and a great 20 + fish day. They all came on a jerkbait i was using 8 # fluoro i would re tie after each fish i caught but even doimg that i had a huge slam then the line goes slack. Fish and lure gone. Then i decided to switch to 10# braid after about 30 45 min of not catching one i make a cast and there goes my lure flying into the shallows. Luckily i was able to get it back. I was using a clinch knot with the fluoro and a palomar with braid. Has anyone experienced this and figured a way to combat it. Im guessing ripping on this bait is making the knot tighten to the point of cuttimg the line. Im hoping maybe someone has a better knot or better solution. Thanks and tight lines.

those are some good suggestions. i wouldnt personally use flex seal. i work at a hardware store and hear more fails than success but if its working for you thats great. after a lot of researching going to use the 2 part for a more permanent adhesive. use some sheet metal screws with a screw glue and probably a 3m caulk as a finishing water sealer. imma install the battery ports, fish finder, run the cables for the ff threw the hull, some clips for oar/net, pole holders, and rudder this week. i guess il see what works best lol. hopedully wont have to re do any of this.

thanks guys both those help was thinking of going with loctite marine 2 part epoxy sounds like it will work.

are you running a deep cycle and how many hours does that last approximately.

i was womdering what size battery for running a sonar only? im on a small boat and trying to use as lil spacr and weight as possible.

so im gonna replace the plug for the battery receptacles on my sun dolphin sportsman and im going to run new wires for the boat while im at it. but i was wondering what kind of adhesive would be best for keeping the top half and bottom half of the boat where the rivets are waterproof. im thinking of a 2 part epoxy but if a caulk would work that would be easier to deal with and cheaper. so if anyone has any experience with this or other suggestions would be really appreciated.

Im posting a lil late but oh well. Thanks that all helps. Idk if il ever use it i put word around locally to see if anyone wants to trade but no bites yet lol.

Yeah i did actually change expecting a hit. That could be it. My lure was always close to the end of the retrieve and didnt wanna pull it out the water so i would slow way down then hit it a couple quick times. Ya thats a really good way to look at it. Kinda simplifies things. I am gonna be able to get a couple hours after work thurs to throw some baits around. So il take these things in consideration and see if i cant get a few extra hook ups!

Sounds good i will have to try that and see what happens.