I do have a jack plate and I am not sure if the cables have been replaced before. Im not quite sure what you all were saying about taking the motor loose from the boat to take the cables out? I have already pulled the cables through the tubes to clean and lube, and left my motor attached. I do suspect it to be a pain in the butt to replace, but I will just have to watch out for all of the wiring like you said. I dont think that I will have to pull my gas tank, because the cables run over my cranking battery and out the same holes as the fuel lines and wiring, but I may pull it anyway to make it a little easier and to clean up. Also I doubt that I will do it, but how much is a power steering set up? Thanks for all of your help.