Fairness is a relative term. If all the other things you describe went up in cost like you are talking. I would definately re-negiotiate my salary with my employer to take advantage of me making him more profit.
Rotating the head will be simple, one long bolt through the collar of the head that goes through the shaft. Remove it twist head 180 degrees reinstall. As for the side mount, be very careful, I have tried that in the past and could not get the motor to stay on the gunnel. I finally just built a small L shaped bracket to mount on the front for the TM. Nice looking rig, good luck with her.
Try these, not as good as some of the homemade ones but suitable for mass produced. I like the asprin head and the punisher II
http://www.punisherlures.com/component/page,shop.browse/category_id,38/option,com_virtuemart/itemid,78/
It may have been covered before, but I can not find it. I am looking for a line that is as sensetive as Flourocarbon or Braid, but that will show up under a blacklight. I have seen the Stren Microfuse, but have heard negative feedback on this line. What are some more alternatives out there? What is everyone else using at night?
Ok, devil's advocate here. What do you do if two boats are working a long point from diffrent sides and meet at the apex of the point at the same time? Who gives ground? The rules are there for a reason, but I do agree common courtesy is required by all.
We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.